How To Build and Install a Deck Cable Railing Enclosure

How To Build and Install a Deck Cable Railing Enclosure

Beginners that want to learn how to build and install a deck cable railing enclosure should not feel intimidated by this task. Though you may work up a bit of a sweat, you can accomplish this task with just a little dedication and focus. Read along closely to learn a basic overview of the job.

Make Measurements, Mark It, and Drill Holes Into Your Posts

First, you want to determine the distance between the two end posts, and then the distance between all the posts from one to the other. The posts should be equidistant from each other. Once you mark down their spots on your floor surface, you want to mark on the posts where the cables will be strung through. Mark and measure going down the post, always ensuring that each one has the same number of entry points at the same distances from each other. Using a carpenter’s drill, make the holes in the posts where you will later thread the cables.

Drill Down the Posts and Install the Top Railing

The next step in this how to build and install a deck cable railing enclosure guide is to drill the posts into the ground. Make certain they’re stationed where you marked, equidistant from each other. You will then want to measure a railing made of wood that can follow the whole length of your enclosure. Measure, cut, and then drill that railing into the top of the posts. You can use L brackets to securely fasten these items into the ground or into each other.

Lace the Cables and Secure the Ends

Now it is time to bring out some cable rigging hardware. Starting with one of your end posts, slide the cable into the holes you made with the drill and bring it out the other end. Continue to slide the cable through each of the corresponding holes on the next post over. Once you reach the end, slide a washer and Quick-Connect fitting into that post. Make sure you wear gloves and use one hand to hold the fitting and pull the cable with the other until it is tight. The cable will lock in place.

Then go back to the starting post and spin the washer-nuts with a wrench to tighten each cable. Go from the middle cable up, then go back to the one underneath the middle and work downward. Remove the extra thread at the starting post with a grinder or hacksaw.